Strict Passive Broadband Modeling of Ultra High Voltage CVT Based on Genetic Algorithm

FENG Junjie; ZHANG Guangyong; DAI Lili; WANG Ping

doi:10.14044/j.1674-1757.pcrpc.2017.06.011

您当前的位置：

首页 >

文章列表页 >

Strict Passive Broadband Modeling of Ultra High Voltage CVT Based on Genetic Algorithm

更新时间：2024-09-14

- Strict Passive Broadband Modeling of Ultra High Voltage CVT Based on Genetic Algorithm
- POWER CAPACITOR & REACTIVE POWER COMPENSATION Vol. 38, Issue 6, Pages: 54-59(2017)
- 作者机构：
  
  1. 国网山西省电力公司检修分公司
  2. 太原工业学院
  3. 华北电力大学
- 作者简介：
- 基金信息：
- DOI：10.14044/j.1674-1757.pcrpc.2017.06.011
  CLC： TM451.2
- Published：2017，
- 稿件说明：
移动端阅览
[1]冯俊杰,张广勇,戴丽莉,王平.基于遗传算法的特高压CVT严格无源宽频建模[J].电力电容器与无功补偿,2017,38(06):54-59+74.

FENG JUNJIE, ZHANG GUANGYONG, DAI LILI, et al. Strict Passive Broadband Modeling of Ultra High Voltage CVT Based on Genetic Algorithm. [J]. Power capacitor & reactive power compensation, 2017, 38(6): 54-59.
[1]冯俊杰,张广勇,戴丽莉,王平.基于遗传算法的特高压CVT严格无源宽频建模[J].电力电容器与无功补偿,2017,38(06):54-59+74. DOI： 10.14044/j.1674-1757.pcrpc.2017.06.011.

FENG JUNJIE, ZHANG GUANGYONG, DAI LILI, et al. Strict Passive Broadband Modeling of Ultra High Voltage CVT Based on Genetic Algorithm. [J]. Power capacitor & reactive power compensation, 2017, 38(6): 54-59. DOI： 10.14044/j.1674-1757.pcrpc.2017.06.011.

摘要

针对某特高压变电站内串补平台侧隔离开关操作导致的特高压CVT故障

建立精确的特高压CVT宽频等效电路模型

有助于进行CVT暂态故障的仿真研究。本文采用基于遗传算法的建模方法对特高压CVT进行宽频建模。首先

利用矢量网络分析仪分别测量电容分压器各分压电容的宽频阻抗参数和电磁单元的散射参数;其次

利用基于遗传算法的建模方法分别建立电容分压器及电磁单元的宽频等效电路模型

且所建模型严格无源;最后

在特高压CVT一次侧施加冲击信号

在CVT的不同部位进行测量

并在EMTP中建立特高压CVT电路模型

对实验过程进行仿真

将仿真结果与实际的实验结果进行对比验证了模型的准确性和有效性。

Abstract

In view of the fault of UHV CVT due to disconnector operation at the serial compensation platform side at certain UHV substation

the accurate UHV CVT broad band equivalent circuit model is set up

which is helpful for simulation study of the transient fault of the CVT.In this paper

the broad band model for UHV CVT is set up by the model set up method which is based on the genetic algorithm.Firstly

the vector network analyzer（VNA）is used to measure the broadband frequency-dependent impedance of the capacitor divider and the scattering parameter of the electromagnetic unit.Then

the broadband modeling method based on genetic algorithm is used to set up the broad band equivalent circuit model of capacitor voltage divider and electromagnetic unit respectively and the model established is strict passive.Finally

the impulse signal is applied on the primary side of the UHV CVT

the measurements are performed at different positions of the CVT.The UHV CVT circuit model is set up in the EMTP so simulate the test process.The correctness and effectiveness of the model is verified by the comparison of simulation result and the actual experimental result.

关键词

特高压CVT遗传算法宽频模型严格无源

Keywords

ultra-high voltage CVTgenetic algorithmbroadband modelstrict passive

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Cascaded H-bridge APF Neural Network Current Tracking Control Based on Improved GA Optimization

Synthetical Analysis of Var Optimization Methods of Electric Power System

Reactive Power Optimization of Distribution Network Based on Adaptive Genetic Algorithm

Reactive Plan Optimization of Distribution Network Based on the Improved Genetic Algorithm

Improvement and Application of Partition Iteration Algorithm of Reactive Power Optimization

Related Author

XING Liyun

LI Ran

WANG Ce

SHEN Jianqiang

JIN Jian-feng~2

WENG Li-min~1

LIU Hui-jin1

WANG Jian-xun1

Related Institution

College of Electrical and Information Engineering, Beihua University

郑州450004

Wuhan University Electric Engineering Institute

Zhengzhou Power School of Higher Special

Luoyang Power Company

⁰