Applications of Finite Control Set Model Predictive Control in Power Electronics Device

GUO Chujia; YAN Tian; ZHANG Aimin; ZHANG Hang

doi:10.14044/j.1674-1757.pcrpc.2018.05.029

您当前的位置：

首页 >

文章列表页 >

Applications of Finite Control Set Model Predictive Control in Power Electronics Device

更新时间：2024-09-14

- Applications of Finite Control Set Model Predictive Control in Power Electronics Device
- POWER CAPACITOR & REACTIVE POWER COMPENSATION Vol. 39, Issue 5, Pages: 167-171(2018)
- 作者机构：
  
  1. 西安交通大学
  2. 西安机电信息技术研究所
- 作者简介：
- 基金信息：
- DOI：10.14044/j.1674-1757.pcrpc.2018.05.029
  CLC： TM76
- Published：2018，
- 稿件说明：
移动端阅览
[1]郭楚佳,燕天,张爱民,张杭.离散集模型预测控制在电力电子装置中的应用[J].电力电容器与无功补偿,2018,39(05):167-171+177.

GUO CHUJIA, YAN TIAN, ZHANG AIMIN, et al. Applications of Finite Control Set Model Predictive Control in Power Electronics Device. [J]. Power capacitor & reactive power compensation, 2018, 39(5): 167-171.
[1]郭楚佳,燕天,张爱民,张杭.离散集模型预测控制在电力电子装置中的应用[J].电力电容器与无功补偿,2018,39(05):167-171+177. DOI： 10.14044/j.1674-1757.pcrpc.2018.05.029.

GUO CHUJIA, YAN TIAN, ZHANG AIMIN, et al. Applications of Finite Control Set Model Predictive Control in Power Electronics Device. [J]. Power capacitor & reactive power compensation, 2018, 39(5): 167-171. DOI： 10.14044/j.1674-1757.pcrpc.2018.05.029.

摘要

电力电子装置是一类混成系统

设计控制器时必须考虑这一特性。离散集模型预测控制（FCS-MPC）可以很好地将离散信号与连续信号通过相应的模型相连接

研究电力电子装置的离散集模型预测控制是对常规控制的补充

具有重大意义。本文为三相电压型电力电子变换器设计了离散集模型预测控制器。首先

建立了控制变量的矢量预测模型

旨在简单直观实现变换器非线性控制的同时提高其响应速度。其次

选取复数域电流矢量信号为基础设计目标函数

在省略坐标变换的同时避免了过电流的问题。最后

针对离散集模型预测控制计算量大的问题

建立了相邻矢量选取原则

大大减少了计算量。仿真结果表明

电力电子装置的离散集模型预测控制可以提高其动态响应速度

建立的相邻矢量选取原则在保证输出电流质量的前提下

大大减少了控制器计算量

为硬件实现奠定了基础。

Abstract

Power electronic device is a hybrid system and this feature shall be considered in the design ofcontroller. FCS-MPC can connect the discrete signal and the continuous signal by the corresponding mod-el. Study of FCS-MPC control for power electronic device is the supplementary of conventional control. Inthis paper

a FCS-MPC controller is designed for the three-phase voltage power electronic inverter. First-ly

the predictive model expressed by vector is set up with aim of achieving non-linear control in simpleand intuitive method and

at the same time

also improving its response speed. Then

complex field cur-rent vector signal is taken as basic design objective function

which

at the time of omitting coordinate con-version

avoids the over current issue. Finally

as for the issue of complex calculation

a neighbouring vec-tor selection principle is proposed

which decrease lots of calculation online. It is shown by the simulationresult that FCS-MPC for power electronic device can improve its dynamic response speed

the establishedneighbouring vector selection principle can

at the premise of assuring output current quality

reducegreatly the calculation of the controller and lay a foundation for the hardware implementation.

关键词

离散集模型预测控制（FCS-MPC）电力电子装置逆变器

Keywords

finite control set model predictive control（FCS-MPC）power electronics deviceinverter

references

Views

151

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Flexible Voltage Support and Control of Distributed Power Inverter at Grid Fault

Study on Coordination Control Strategy of Adjustable Wind-solar-diesel-battery AC/DC Mirco-grid

Control Strategy for Power Quality Improvement of Inverter Based on Disturbance Observer

Model Predictive Control Strategy for Multi-level Cascaded H-bridge Inverter

Related Author

SUN Shaojie

MIAO Jian

WU Wenyi

ZHAO Qianyu

孙凯

陈伟斌

翟晓卉

LI Dahai

Related Institution

College of Mechanical and Electronic,Tarim University

National Defense Academy of PLA Academy of Military Sciences

Tianjin University,Key Laboratory of Art Grid of Ministry of Education

Metering Center

College of Electrical Engineering,Zhengzhou University of Science and Technology

⁰