Reactive Power Planning of Distribution Network Considering Power Factor Constraints

XING Jie; QUAN Zhaolong; YUAN Zhiqiang

doi:10.14044/j.1674-1757.pcrpc.2021.05.004

您当前的位置：

首页 >

文章列表页 >

Reactive Power Planning of Distribution Network Considering Power Factor Constraints

更新时间：2024-09-14

- Reactive Power Planning of Distribution Network Considering Power Factor Constraints
- POWER CAPACITOR & REACTIVE POWER COMPENSATION Vol. 42, Issue 5, Pages: 21-27(2021)
- 作者机构：
  
  1. 东华大学信息科学与技术学院
  2. 上海电力设计院有限公司
- 作者简介：
- 基金信息：
- DOI：10.14044/j.1674-1757.pcrpc.2021.05.004
  CLC： TM715
- Published：2021，
- 稿件说明：
移动端阅览
XING JIE, QUAN ZHAOLONG, YUAN ZHIQIANG. Reactive Power Planning of Distribution Network Considering Power Factor Constraints. [J]. Power capacitor & reactive power compensation, 2021, 42(5): 21-27.
DOI：

XING JIE, QUAN ZHAOLONG, YUAN ZHIQIANG. Reactive Power Planning of Distribution Network Considering Power Factor Constraints. [J]. Power capacitor & reactive power compensation, 2021, 42(5): 21-27. DOI： 10.14044/j.1674-1757.pcrpc.2021.05.004.

摘要

目前大型城市配电网负荷低谷时段容性无功倒送现象日益凸显

危及电网安全稳定运行。基于此背景

研究了计及功率因数约束的配电网无功规划方法。首先

建立了考虑功率因数约束的含电抗器和电容器的综合无功规划模型

模型考虑在配电系统中同时配置电容器和电抗器

以规划期内无功补偿设备投资和有功网损成本之和最小为目标函数

在约束中增加了节点功率因数约束;然后

推导了功率因数对无功的灵敏度计算公式

采用基于功率因数无功灵敏度的改进遗传算法求解所建模型

对配电网感性和容性无功补偿设备的容量和选址进行协调优化

所求优化方案可解决配电网线路电缆化发展过程中低负荷时产生的无功倒送和功率因数越限问题;最后

以典型的高压配电网作为算例验证模型和算法的有效性。

Abstract

At present

capacitive reactive power reversal is becoming increasingly prominent in the period of light load in large urban network

which endangers the safe and stable operation of power grid. In this context

the reactive power planning method of distribution network considering power factor constraints is studied.First

the integrated reactive power planning model considering the power factor constraints and containing reactor and capacitor is set up. The simultaneous allocation of capacitor and reactor in the distribution system is considered in the model so to plan the minimum sum of the investment of reactive power compensation equipment and the cost of active power loss as objective function. The node power factor constraints are added in constraints. Then

the calculation formula of sensitivity of power factor to the reactive power is derived.An improved genetic algorithm based on power factor sensitivity is used to solve the established model.The coordination and optimization of capacity location selection of inductive and capacitive reactive power compensation equipment of the distribution network is performed. And the obtained optimization scheme can solve such problem as reactive power reversal and out of limit of power factor in low load during the cable development process in the distribution network. Finally

the effectiveness of the model and the algorithm of the model is verified by the example of typical high voltage distribution network.

关键词

无功规划高压配电网功率因数改进遗传算法

Keywords

reactive power planninghigh voltage distribution networkpower factorimproved genetic algorithm

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Study on Reactive Power Optimization Method with Large Scale Access Condition of Cables in Urban Distribution Network

Case Analysis and Solution of Low Power Factor Caused by Distributed Photovoltaic Grid Connection

Study on Fuzzy Control of Low Voltage Power System Integrated Compensation

Application Example of Local Compensation on the Electric Motor for Driving Water Pump in the Power Plant

The Application of Harmonic Filtering Installation to Extra-high-power andHigh-impedance Electric Arc Furnace

Related Author

XING Jie

CAO Ruilin

SHAO Hongxing

LI Xin guang 2

QIN hua biao 1

LAI Sheng li 1

YANG Jie 1

Dong Shijian

Related Institution

Qingdao Eastsoft Communication Technology Co, Ltd

广州510405

Dept. of Physics & Electronics, Guangzhou University

College of Electronics and Information, South China University of Technology

Panzhihua New Vanadium Steel Limited Company Power Plant

⁰